Hand Held Products 4410, 4710 Power Saving Mode

2 - 16 IMAGETEAM™ 4410/4710 User’s Guide
Note: ‡ A one- to three digit number and Save are
required after reading this programming symbol. Refer to the
Programming Chart (inside back cover).
Power Saving Mode
This provides control of the Imager’s power consumption, as follows:
Low Power draws low (50%) LED current during image capture, allowing one
read attempt only for each trigger pull. The Imager is less tolerant of hand
movement during the read attempt, and powers down after the image capture is
complete.
Medium Power draws a normal LED current during image capture which
enhances motion tolerance.
Medium Power attempts to read as long as the
trigger is pulled, going into a “doze” (low power) state after each read attempt.
The Imager powers down ten seconds after the image capture is complete.
Normal Power draws a normal LED current, attempting to read as long as the
trigger is pulled or a decode is in process. The Imager doesn’t go into a “doze”
state after each read attempt, but will power down after two minutes if Power
Hold Mode is turned Off.
Low Power Medium Power
* Normal Power