Hand Held Products 4410, 4710 Multiple Symbols, No Read

IMAGETEAM™ 4410/4710 User’s Guide 2 - 47
Multiple Symbols
Note: This feature does not work when the Imager is in Low Power mode.
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the Imager’s trigger. If you press and hold the
trigger, aiming the Imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. Data is output as the imager finds and
decodes the symbols. The imager attempts to find and decode new symbols as
long as the trigger is pulled. When this programming selection is turned
Off , the
Imager will only read the symbol closest to the aiming beam.
No Read
With No Read turned On , the Imager notifies you if a code cannot be read. In
the Quick*View Scan Data Window (see "Scan Data Window" on page 7-4), an
“NR” appears when a code cannot be read. If No Read is turned
Off , the “NR”
will not appear.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message using the Data Formatter (see page 2-37). The
hex code for the No Read symbol is 9C.
On * Off
On * Off