The blade assembly may be easily removed, by inverting the blender, pressing down on the quick release handle, turning it counterclockwise until it stops, as shown in figure 10a, and then lifting up, see figure 10b.
Figure 10.
Wash the blade assembly under running water. Do not place the blade assembly in the dishwasher or allow it to stand in water. This will tend to wash out the lubricant. After cleaning, rinse thoroughly and dry before using.
quick release handle of the blade assembly and turn clockwise to the stop. The blade assembly is then back in place.
3.If you have not already done so, remove the motor drive cover and place the blender on the mono drive. Turn counterclockwise to lock the blender in place, see figure 12a.
Placing Blender into Operation
Make sure that the switch is in the Off position, “O/Off.” Unwind the electrical cord to the necessary length and plug it into wall outlet. The blender is now ready for operation.
-
Figure 11.
2.To assemble or reassemble blade assembly into the blender, insert the blade assembly into the blender jar as shown in figure 11, press down on the
Figure 12.
Normally when blending, the blender jar should be filled with the entire amount of material to be blended, if possible, before switching the appliance on. The cover and cover closure should always be in place after filling the blender jar, and before switching the power unit to On. Any subsequent additions to the blended material should be made through the cover opening, see figure
13.For solids and/or granular material, remove the cover closure/funnel to add the material, as shown in figure 13a. For liquids, the closure/funnel may be left in place and the liquids added by pouring them into the closure/funnel, see figure 13b.
16
