Bosch Appliances PCK755UC manual Important Information, Requirements for the cabinet

IMPORTANT INFORMATION
Requirements for the cabinet							3 - Depending on the model, the clips and the
Figure 1a							watertight seal (lower edge of the cooktop)
							may already be fitted; if this is the case, do not
							remove them under any circumstance.
							The seal ensures that the entire work surface
		E					will be watertight, and prevents water seepage.
							If this item has not been fitted in the factory,
							remove the pan supports and the gas burner
				C	F		covers and diffusers from your cooking hob,
							and turn it upside down.Now fit the adhesive seal
				B			supplied with the appliance onto the lower edge
							of the cooking hob,Fig. 2a,remove the clips from
	D
							the attached accessories bag and screw them
	A						into the lower points designed for this purpose,
							Fig. 2 b. Place the cooktop in the middle of the
							opening where it is to be inserted into the kitchen
							unit.
							Once the hob is fitted you should turn the clip
							and tighten the screw as shown in Fig. 2b. For
							disassembly, unscrew the clip and proceed in the
							reverse manner.
							If the oven is not installed under the cooktop,
A- Minimum 6” (152 mm)		D- Minimum 2” (51 mm)					place a separator of non-flammable material to
B- Minimum 6” (152 mm)		E- Minimum 30” (762 mm)					prevent access to the lower part of the cooktop.
C- Minimum 30” (762 mm)		F- Minimum 18” (458 mm)					To install the cooktop over an oven, check the
Maximum depth of cabinets installed above							dimensions given in the installation manual.
cooktop: 13" (330 mm.)							Figure 2a
Appliance installation
				min. 10”
min. 29 /16”
191/	”		221/ ”
4				16
Figure 1b							Figure 2b
	221/ ”
	16
				13/	”
				4
							Figure 2c
		11/	16	”	191/	”
		1”
					4
							17