SC3100
System Initialization
5.0System Initialization
The following describes the System Initialization Procedures for the SC3100 Radio communicator.
5.1System Initialization Procedures
Contact the Central Station SAFECOM computer operator. Then verify that the following information is entered in the SAFECOM SC9000 computer account for the specific SC3100 you are working on.
You must build an account into the SAFECOM SC9000 computer before the computer will recognize and place
I SAFECOM ST1000 v2.42 I
02/12 10:45:57
02/12 09:12:22 | 122>STARTUP | |
02/12 09:13:26 | 301>AC TROUBLE | |
02/12 09:14:42 | 152>ALARM ZONE2 | |
02/12 09:15:57 | 202>2133 | E1 |
|
|
|
*SELECT REMOTE 456 SETUP 1
S/N:PID:
Framer: Channel:
Poll Interval: : :
Vline: Vaccount: Notes:
TX RX MODE HP
** - - - - -
F1= Copy | PGDN= More Setup |
F2=Delete | F9=Help |
|
|
SAFECOM SC9000 COMPUTER
Figure 6: System Parameters
•S/N: This number must match the CPU Serial Number listed on the label of the SAFECOM SC3100.
•PID: This number must match the PID number on the label of the SAFECOM SC3100.
•Framer: This should correspond to the framer that is to be assigned to this unit.
•Poll Interval: This is the time in hours : minutes : seconds that the unit in the field is to be polled by the Central Station.
•Vline: The number placed here will report to the Automation System as coming in from “line XX”
•Vaccount: The number placed here will report to the Automation System as signal coming from “account XXXX”.
•Notes: This area is used to note the account information such as: Address, Customer, Account #, Install date, etc.
| SC3100 Operation and Installation Guide |
|
|
| |
© 2004 Bosch Security Systems | Page 21 |
