Bosch Appliances manual Installation 4.0Installation Procedures, 4.1SC3100 Radio Communicator

SC3100

Installation

4.0Installation Procedures

This section describes the installation procedures for the SC3100 Radio Communicator.

4.1SC3100 Radio Communicator

Mount the SC3100 at the location determined from the considerations discussed in Section 3.0. The total weight of the SC3100 is about one pound (0.5 kg) with the internal 12 VDC battery installed.

The SC3100 is normally installed in an upright position in the bottom and inside of the host alarm panel enclosure (see Figure 3).

SAFECOM ANTENNA

CONNECTOR

HOST ALARM PANEL BATTERY

HOST ALARM PANEL

SAFECOM

SC3100

FACTORY SUPPLIED RF COAXIAL CABLE

SAFECOM SC3100

RADIO COMMUNICATOR

Figure 3: SC3100 Radio Communicator

4.2Antenna

Each SC3100 Radio Communicator unit is shipped from Bosch Security Systems with a 20 in. (50.8 cm) antenna coaxial cable assembly to mount the antenna directly on the host alarm panel enclosure (as shown above). The unit is also shipped with a 2" x 2" antenna mounting L-bracket for mounting the antenna directly on the side of the host alarm panel or for remote installation of the antenna.

If mounting the antenna directly on the host alarm panel, use the attached antenna coaxial cable assembly to connect the SC3100 radio communicator to the antenna (on the top of the host alarm panel enclosure). See the following figure:

ANTENNA CONNECTOR

MOUNTING WASHER

MOUNTING WASHER

HOST ALARM

PANEL

ENCLOSURE

WITH KNOCK-

OUT REMOVED

Figure 4: SC3100 Antenna

	SC3100 Operation and Installation Guide
© 2004 Bosch Security Systems	Page 19	90026-201D