Bosch Appliances manual SC3100 Circuit Board Components

SC3100

SC3100 Circuit Board

2.0Circuit Board

2.1SC3100 Circuit Board Components

The following describes the function of the headers, LEDs, and some of the significant components located on the SC3100 Communications Panel circuit board.

MAIN MOLEX CONNECTOR

“RJ31X” EIGHT CONDUCTOR MODULAR JACK

“DIALER” EIGHT

CONDUCTOR

MODULAR JACK

SYSTEM RADIO STATUS STATUS

JP-1 RESET JUMPER

MICROPROCESSOR

CHIP, CONTAINS THE

CPU SERIAL NUMBER

AND PID

SP100 BATTERY

CHARGER BOARD

JP-2RADIO INTERFACE

Figure 2: SC3100 Circuit Board

System Status LED

The System Status LED is a bi-color (red & green) LED. It illuminates to indicate the status of radio communications between the SC3100 Radio Communicator and the Central Station. It also is used to indicate a LOW INTERNAL BATTERY condition, and/or identify a hardware failure on the SC3100 during system initialization.

Radio Status LED

The Radio Status LED is a bi-color (red & green) LED. It illuminates to indicate transmit (red) and receive (green) Status of the SC3100 internal radio module. This indication is helpful when sending and receiving signals.

RJ31X Modular Jack

This is a standard 8 pin RJ31X compatible female modular phone jack which is used for connecting the SC3100 to the premises RJ31X telephone jack (Tip & Ring on PINS 4 & 5 and House Phone return from the alarm panel on Pins 1 & 8).

Dialer Modular Jack

This is a standard eight-pin RJ31X compatible female modular phone jack which is used for connecting the SC3100 to the alarm panel “phone line in & house phone out” (Tip & Ring to alarm panel on Pins 4 & 5 and house phone return from the alarm panel on Pins 1 & 8).

Main Interface Molex Connector

This is a specially keyed, female Molex connector. This connector is provided for interfacing the required 12VDC power from the host alarm panel auxiliary power supply. The SC3100 comes supplied with a mating male Molex connector with a flying lead wiring harness for wiring the 12VDC power. The 12 VDC power is provided by the Red (+) and the Black (-) wire leads on the Molex connector wiring harness.

	SC3100 Operation and Installation Guide
© 2004 Bosch Security Systems	Page 11	90026-201D