Rinse Aid
Figure 9
To achieve proper drying, always use a liquid rinse aid, even if your detergent contains a rinse aid or drying additive.
Note: The dishwasher indicates low rinse aid by turning on the Refill Rinse Aid indicator LED (for units without a display) or symbol (for units with a display). 
If this light is on, you need to refill the rinse aid dispenser by following the directions below.
Adding Rinse Aid
Open the rinse aid reservoir and add liquid rinse aid by pouring over the arrow.
Turn the arrow to adjust the amount of rinse aid dispensed (see Figure 9). Wipe up any excess rinse aid that may puddle when the dispenser reservoir is full.
The indicator light will go out a few moments after the dishwasher door is shut.
To decrease | To decrease |
streaks on glass | spots on glass |
Dishwasher Cycles and Options
Wash Cycles (model dependent)
Heavy: Best for cleaning items with
Auto: With our most complex soil sensing capability, this cycle is perfect for use with mixed loads of dishware and varying amounts of food soil. This is the most flexible cycle and is a good choice for everyday use.
Normal: Thoroughly cleans a full load of normally soiled dishes.
Note: The Energy Guide Label was based on this soil sensing cycle with all available options turned off. As prescribed in the energy test procedure, the unit was tested without any Rinse Aid in the Rinse Aid dispenser. A single dose of detergent was used in the Detergent Dispenser, with no detergent used in the prewash. The test was conducted with the upper rack in the lowest position.
Express: Cleans lightly soiled dishes and reduces overall wash time. Use this cycle to clean glasses and dessert dishware that may need to be reused at the same event.
Half Load: Reduces the energy and water consumption when washing small, lightly soiled loads that fill approxi- mately half of the dishwasher’s capacity.
Wash Cycle Options
Delay Start (model dependent): This option allows you to delay the start time of your dishwasher up to 19 hours.
Sanitize: The Sanitize feature is available only when running the Heavy, Auto, Normal and Half Load cycles. Select one of these cycles, press the “Sanitize Option” button and then press Start to activate the Sanitation features. The
technical sanitation measures may also improve the drying results. The sanitize LED or symbol will light at the end of the cycle when sanitation requirements are met.
Note: The dishwasher automatically defaults to Auto Wash when turned off and back on. If you used the sanitize option in your last cycle, the dishwasher will default to Auto Wash with the Sanitize option selected when you turn it on.
11
