Wash Cycle Information
Note: To save energy, this dishwasher has a “Smart Control” where the sensors in the dishwasher automatically adjust the cycle length, temperature and water changes based on the amount of food soil and the incoming water tempera- ture. The “Smart Control” makes decisions that can cause the cycle time and water usage to adjust intermittently. Wash cycle times are based on 120°F water supply. If your household water supply is different than 120°F, your
dishwasher’s cycle times may be impacted.
Table 2 - Wash Cycle Information
| Heavy | Auto | Normal | Express | Half Load |
|
|
|
|
|
|
cycle time | 135 min | 115 min | 30 min | 99 min | |
|
|
|
|
|
|
cycle time with Sanitize | 135 min | 125 min | not available | 120 min | |
|
|
|
|
|
|
water consumption | 13.1 L | ||||
| 3.5 gal | ||||
|
|
|
|
|
|
wash temperature | |||||
| |||||
|
|
|
|
|
|
rinse temperature | 72°C | 50°C | 72°C | ||
| 162°F | 122°F | 162°F | ||
|
|
|
|
|
|
|
|
|
|
|
|
Note: Only sanitizing cycles (Heavy, Auto, Normal and Half Load) have been designed to meet the requirements of 6 for soil removal and sanitization efficacy. There is no intention, either directly or indirectly, that all cycles have passed san- itization performance tests.
Operating the Dishwasher
Start the dishwasher:
1Open the door and press the On/Off button.
2Select a cycle and desired options.
3Close the door to begin the cycle.
Delay start (model dependent):
1Open the door and press the On/Off button.
2Select a cycle.
3Press and hold the Delay Start button. Release when the desired delay time is shown in the display window.
4Close the door to begin the cycle.
Cancel a cycle:
1Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2Press and hold the two Cancel/Reset buttons for 3 seconds.
3Close the door and wait approximately 1 minute until the dishwasher completes the cycle.
4Open the door and press the On/Off button. You may now start a new cycle.
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CARE- FULLY during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt a cycle:
1Open the dishwasher door just far enough to expose the controls panel. Be careful of hot water that may splash out.
2Press the On/Off button to turn the unit off.
3Wait at least 10 seconds before fully opening the dishwasher door.
4To resume the cycle, press the On/Off button and close the dishwasher door.
12