DRAIN HOSE CONNECTION
THESE INSTALLATION
INSTRUCTIONS ARE
INTENDEDFORUSEBY
QUALIFIEDINSTALLERS
Be sure to follow your national and local codes at all times.
Drain Hose
•Before beginning, turn off the water supply!
•The access hole for the drain hose should be 1.25” (32 mm) diameter.
•Use the hose clamps and rubber connection hose (Figure 3) to connect the drain hose to the sink, disposer or air gap (Figure 14).
Openings for drain lines must be installed in the marked areas as shown in Figures 8 and 9 to avoid interference with the dishwasher frame or other components.
Drain Hose | Air Gap | |
| ||
in Sink with |
| |
Air Gap/ No |
| |
Disposer |
| Rubber |
|
| |
|
| Connector |
min.20” (500 mm) | clearanceto floor | Trap |
|
| |
|
| Figure 12 |
|
| Air Gap |
Drain Hose |
| |
in Sink |
|
|
with Air |
|
|
Gap & |
| Rubber |
Disposer |
| Connector |
|
| |
min.20” (500 mm) | clearanceto floor | disposer |
|
|
Trap
Figure 13
CAUTION
Failure to provide the proper drain connection height, 20” (508mm) above floor level with high loop or air gap, will result in improper draining of the dishwasher. Improper draining may cause damage to the dishwasher.
Drain Hose | G, Fig 3 |
Connected |
|
to Sink |
|
Figure 14
www.boschappliances.com ENGLISH - 9