ELECTRICAL SUPPLY CONNECTION
THESE INSTALLATION
INSTRUCTIONS ARE
INTENDEDFORUSEBY
QUALIFIEDINSTALLERS
Connecting Electrical Supply
Be sure to follow all local and natio- nal electrical codes and ordinances.
•Install strain relief or conduit connector into opening on power supply box.
•Strip the insulated wires, being extremely careful not to strip too much insulation.
•Insert and securely fasten into strain re- lief,
•Twist wire connectors tightly onto the wires, ensuring that no bare wiring is exposed (from insulated wires).
•Press wires back into
•Securely fasten the
*Junction box located at the bottom right front of the dishwasher base.
WARNING
ELECTRICALSHOCKHAZARD
•DISCONNECT ELECTRICAL POWER AT THE CIRCUIT BREAKER BOX OR FUSE BOX BEFORE INSTALLING THE DISHWASHER.
•ELECTRICALLY GROUND DISH- WASHER.
•USE COPPER CONDUCTORS ONLY. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
Correct Connection in Junction Box |
Black to Black |
White to White |
Green or Bare |
to Green or Bare |
U.L. listed |
Conduit |
Connector |
or Strain |
Relief |
Figure 17
Grounding Instructions
This appliance must be connected to a grounded metal permanent wiring system; or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the dishwasher. The dishwasher must be properly grounded before operating. Make sure that the dishwasher is connected to a suitable ground in compliance with the NATIONAL ELECTRICAL CODE, in the United States, or the CANADIAN ELECTRIC CODE C22.1- latest edition, in Canada as well as any pro- vincial/state or municipal or local codes that apply.
Incorrect Connection in Junction Box
Figure 18
www.boschappliances.com ENGLISH - 11