Vidikron Vision 50 manual Turning on the Power, Connecting to AC Power, Power source

Installation

Projector: The Vision 50 ships with various types of AC power cords. Choose the one that is appropriate to your locale.

Plug the female end of the power cord into the AC receptacle on the rear of the projector (AC 100V ~ 240V). Then, connect the other end to your AC power source.

Connecting to AC Power

Power

switch

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.

Caution	The input voltage to the AutoScope lens motor must be between 100 and
	120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC
	power source!

AutoScope Lens Motor (Rear)

to

110 VAC Power

Power AC Input

Switch

1.Turn on your source components.

2.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see above).

3.Turn on the main power switch at the rear of the projector. The POWER LED lights orange. The LAMP and TEMP LEDs light red briefly, then go out.

4.Press the ON button on the remote control to turn on the Vision 50. The POWER LED flashes orange to indicate that it is warming up.

5.When the projector is ready for use, the POWER LED lights green.

6.“Searching...” appears on the screen before the Vision 50 identifies the input signal and remains there until a valid signal is detected.

7.If an incompatible input signal exceeds the range of the projector, a “No signal supported” message appears on the screen. This message remains on the screen until you change the input signal.

3.7

Turning on the Power

Vidikron Vision 50 Series Owner’s Operating Manual 31