FINAL ADJUSTMENTS
Door Tension Adjustment
(only in SHI and SHV models)
After installation of the dishwasher, open and close the door several times to make sure that it does so with ease. If the door closes too quickly or if the door falls open, the spring tension needs to be adjusted.
To Adjust the Spring Tension
•Obtain Spring Tension Screws (2) out of the SHI/SHV parts bag (see Figure 3).
•Insert the screws in the right and left sides and adjust spring tension as shown (see Figure 22).
Leveling the Dishwasher
Raising the Rear
The rear leveling leg is adjusted by turning the center screw at the front of the dishwasher.
Raising the Front
The front leveling legs are adjusted by rotating the leveling legs on the front left and right sides of the dishwasher.
•Use a screwdriver and tap the end lightly with a hammer to turn the legs (see Figure 23).
Note: If additional height is needed: Shims may be added under the leveler feet.
Adjust screws |
on right and |
left sides |
Torx T 20 |
Figure 22
Torx T 20 |
Figure 23
14 - ENGLISH www.boschappliances.com