4.Next place the mixing bowl cover on the bowl. Make sure arrows on cover and bowl are aligned, so that tabs on bowl fit into channels in cover and then turn cover clockwise until tab on cover enters cover interlock and turn until tab clicks into place, figure 6b.

Figure 5.

5a. Cover w/dual feeding tubes

5b. Cover w/integral feeding tube

5c. Pusher/measuring cup

5d. Multifunction blade w/protective cover

5e. Dough hook

5f. Whipping whisk

5g. Fine grating disc

5h. Reversible slicing disc

5i. Reversible coarse grating disc

5j. Dough hook

5k. Whipping whisk

3.Engage the multifunction blade on the dual drive of the power unit by placing it over the center column, as shown in figure 6a. Once in place, check to make sure the multifunction blade has engaged the dual drive by turning the multifunction blade while pushing down until it stops.

Figure 6.

The cover should be in place whenever the power unit is in operation. The cover serves to prevent accidental contact with the moving blade. Also, the power unit will not operate unless the tab on the cover is in place and has engaged the safety cover interlock.

Placing into Operation w/Multifunction Blade

Make sure that the power unit is on a smooth, clean, suitable work surface and switched to the Off position, “O/Off.” Pull the electrical cord out to the necessary length and plug into a convenient outlet. The mixing bowl with multifunction blade is now ready for operation. The multifunction blade should only be used using the momentary contact position ”M” to prevent over processing of food.

Sample recipes may be found in the recipe section, at the back of this manual.

11