6.Operate unit with rotary switch. Once the attachment is in place, the speed of its moving components can be controlled through the use of the rotary switch at the front of the power unit. See figure 2. The rotary switch has six or four positions, depending on the model you have:

All MCM models have the following:

a.“M,” a momentary “pulse” position that provides full speed and power for the time it is held in position.

b.“O/Off,” the off position.

The MCM 5000 and 5100have2speeds c. Two speeds labeled 1 and 2.

Speed 1 is the lowest speed.

The MCM 5200 has 4 speeds:

d.Four speeds labeled 1, 2, 3 and 4. Speed 1 is the lowest speed. The speed increases with each succeeding step up to the highest speed, speed 4.

All models of the Bosch Food Processor incorporate a built-in safety cutout switch to protect the motor against overheating. If the safety becomes activated, the power unit will stop. If power unit should stop even though there is power to the unit see TROUBLESHOOTING at the back of this manual .

7.Turn power unit off.

When your work with the attachment is completed or the capacity of the batch-feed attachment has been reached, turn the power unit to the Off position, “O/Off,” and unplug.

8.Remove the attachment. Remove the attachment from the power unit, per instructions for the specific attachment being used.

9.Continue use.

If the attachment was of the batch-feed type and you wish to continue using the attachment, empty the bowl or jar of the attachment per its specific instructions and reinstall the attachment as before. Repeat steps 5 through 8 as often as necessary to complete work.

10.Work completed, remove attachment.

If the attachment is of the continuous feed type or is the batch type and you have completed the work you wished to perform with the attachment, remove the attachment from the power unit per the instructions for the specific attachment being used.

11.Place contents (batch-feed type). If the attachment is the batch feed type, disassemble per the specific attachment’s instructions and place the contents in a suitable container.

12.Care and cleaning.

Once you have completed working with the Bosch Food Processor, the next step is to disassemble and clean the attachments. If you wish to use another attachment, please return to step 3, above.

Power unit

With the power unit turned Off and unplugged, it should be cleaned only with a clean, damp cloth. Then wipe off the safety motor drive cover and reinstall on the power unit, if necessary. Never use coarse or caustic cleaning products to clean the power unit. Never immerse the power unit in water.

The power unit may be left on the counter or stored for future use. If the unit will be stored, store the cord and lift the power unit and place in your chosen storage area.

9