Bosch Appliances VP-CFGSFT 3.2Connecting the VP-RS2BLNXConfiguration Tool, Number Description

CTFIDConnections en 11

3.2Connecting the VP-RS2BLNX Configuration Tool

It is recommended that the CTFID software be installed prior to connecting the hardware to the serial port. Refer to Section 2 Installing the CTFID, page 6 for additional information.

To see the device output, use a CCTV monitor. Plug the coax connected to the imaging device to one of the BNC connectors of the VP-RS2BLNX. Connect another coax between the second BNC connector and the CCTV monitor. Ensure that the monitor is either auto-terminating or is set to low impedance. See Figure 3.3 for an example of a typical CCTV monitor’s connections.

Figure 3.2 VP-RS2BLNX connections

Number Description

1Power and serial connection

2 Selects mode and baud rate

3BNC connections, passive loop-through, high impedance, video input 1 Vpp nominal, 2 Vpp max.

Connecting the VP-RS2BLNX (Bilinx)

Figure 3.3	Connecting the VP-RS2BLNX Configuration Tool
Number	Description
1	Typical AutoDome version 5.10 or higher, and any other Bilinx device
2	Coax IN
3	Terminal block
4	VP-RS2BLNX
5	PC running CTFID software
6	RS-232
7	Power supply (not provided)
8	Coax OUT
9	Typical CCTV monitor

Bosch Security Systems, Inc. User’s Manual F.01U.141.545 3.09 2009.10