Liquid detergent dispenser
To measure liquid detergent:
1.Pull out the detergent drawer. Press down on the insert and remove the drawer completely.
2.Push the liquid detergent dispenser forward.
3.Insert the drawer again.
NOTICE: Do not use the liquid detergent dispenser with
Starting the cycle
Press the Start/Pause button Indicator lamp lights up and the cycle starts.
NOTICE: If you want to protect the cycle against inadvertent adjustment, select the child lock.
~Child lock; Page 24
During the cycle, the display field indicates the "Finish at" time and, after starting the washing cycle, the cycle duration and the symbols for the cycle progress.
~Display field; Page 16
Child lock
You can secure the washer against inadvertent changing of the set functions. To do this, activate the child lock after cycle start.
To Activate/Deactivate, press Start/Pause for approx. 5 seconds. In the display field, you will see the D symbol.
▯D lit steady: The child lock is active.
▯D blinking: The child lock is active and the cycle selector has been adjusted. To prevent a cycle interruption, set the cycle selector back to the initial cycle. The symbol lights up again.
NOTICE: The child lock can remain activated until the next cycle start even after switching the machine off. Then you must deactivate the child lock before cycle start and if necessary activate it again after cycle start.
Selecting a different cycle
If you have inadvertently started the wrong cycle, you can change this as follows:
1.Press Start/Pause.
2.Select another cycle.
3.Press Start/Pause. The new cycle starts from the beginning.
Pausing/Continuing the cycle
e.g. for soaking ~ Soaking; Page 20
Press Start/Pause. - ¿ - appears on the display panel; washing machine door cannot be opened. To continue the cycle, press Start/Pause.
Cancel cycle
For cycles with a high temperature:
1.Press Start/Pause.
2.Cool the laundry off: Select Rinse.
3.Press Start/Pause.
For cycles with a low temperature:
1.Press Start/Pause.
2.Select Spin/Drain.
3.Press Start/Pause.
Cycle end with rinse stop
Appears in the display field – – – and the indicator lamp on the Start/Pause button blinks.
In order to exit the cycle, set the cycle selector to Spin/ Drain or select a spin speed range, then press the Start/ Pause button.
Cycle end
End appears in the display field and the Start/Pause button indicator lamp is off.
If the cycle status sequence Wash is also flashing in the display field, the washer has detected too much foam during the washing cycle and it has then automatically switched on a rinse to remove the foam.
NOTICE: Use less detergent the next time you run the washer with the same load.
Removing laundry/switching the appliance off
1.Open the front door of the washer and remove the laundry.
2.Turn the cycle selector to the Off position. Appliance is switched off.
3.Turn off the water tap.
NOTICES
▯Do not leave any laundry in the drum. It can shrink or be discolored by the next laundry.
▯Remove any remaining items from the drum and rubber gasket.
24
