Additional Grounding Procedure
Some local codes may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately.
Never ground the dryer to plastic plumbing lines, gas lines or water pipes.
Electrical Receptacle
The receptacle for the dryer cord must be located so that the power supply cord will be accessible when the dryer is in the installed position.
Venting
The WTA 3510, electric vented dryer, is intended to be vented to the outdoors. To prevent
Ductwork
Exhaust ducts should be as straight as possible. Exhaust ducting longer than recommended can extend drying time, can collect lint and may effect dryer performance. Joints should be secured with duct tape. DO NOT use screws to secure joints as lint can collect on the screws. See Step 4, Exhaust Duct, in following section titled INSTALLATION for recommended routing and duct length calculations.
Exhaust Vent Hood
The exhaust duct must end with an approved exhaust vent hood with swing out damper(s). DO NOT use an exhaust vent hood with magnetic latches. To avoid restriction of exhaust the outlet must be a minimum of 12 inches (30 cm) above ground level, or any other obstructing surface. See Figure 17.
Condensate Drain
The WTL 5410, electric condensation dryer, dries by condensing the moisture from the dryer air and then pumping this condensate out of the dryer.
The WTL 5410 must have its condensate hose connected to a suitable drain. See Step 5, Condensate Hose Connection, in the following section titled
INSTALLATION.
Stacking Kit
A stacking kit is supplied with each dryer in order to stack Bosch dryer upon a Bosch washing machine. This part is only necessary if stacking the units is desired.
Stacking Kit with Pull(out(tray - WTZ 1180
As an additional accessory for purchase, Bosch offers a stacking kit for a Bosch washer and dryer that incorporates a
16
