Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into
position (Fig. 6).
Your tool is equipped with a secondary locking
latch to pre vent the ba tter y pac k from
completely falling out of the handle, should it
become loose due to vibration.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when driving (Fig. 1).
BIT STORAGE AREA
(Models 25614 & 25618 only)
Your tool is equipped with a bit and storage
area that is conveniently located in the handle
base where it is always handy and unlikely to
get lost or misplaced (Fig. 5).
BELT CLIP (Optional Accessory)
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall result ing in injury to the ope rator o r
bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig.5).
To use clip, turn tool upside down and attach
to your belt.
INSERTING AND RELEASING BATTERy PACK
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
“OFF” position to help prevent
accidental starts and accidental discharge.
Your tool is eq uipp ed wi th a forw ard/
reversing lever and trigger lock located above
the trigger (Fig. 4). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an “OFF” position.
For f orward rot ation, (wi th ch uck pointe d
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate tri gger lock move lever to
the center off position.
Do not change direction of
rota tion u nti l the to ol
comes to a complete stop. Shifting during
rotation of the chuc k can cause damage to
the tool.
-11-
!
CAUTION
FIG. 5
BELT CLIP
(Optional Accessory)
BIT AND BIT
STORAGE
AREA
!
WARNING
FIG. 4
FORWARD/REVERSING
LEVER & TRIGGER LOCK
!
WARNING
BM 2609140642 05-09:BM 2609140642 05-09 5/19/09 10:16 AM Page 11