BM 2609932486
MICROFILTER DUST CANISTER
The integral dust extraction system collects sanding dust in canister supplied with your sander. For maximum efficiency, the dust canister should be emptied frequently during operation.
!WARNING Your tool is equipped with a dust canister, empty it
frequently, after completion of sanding and before storing the sander. Be
extremely careful of dust disposal, materials in fine particle form may be explosive. Do not throw sanding dust on an open fire. Combustion from mixture of varnishes, lacquers, polyurethane, oil or water with dust particles can occur if there is a static discharge, spark introduced in the box, or excessive heat.
REMOVING AND INSTALLING
DUST CANISTER
To attach dust canister, slide canister support in direction of arrow (A) until it stops. Insert mounting clip into the pocket provided on canister. Then slide canister support through mounting clip in direction of arrow (B) and push onto the dust port (Fig. 4).
To remove dust canister, squeeze release tabs on both sides of canister and simply pull away from the tool (Fig. 5).
MOUNTING CLIP | FIG. 4 |
CANISTER SUPPORT
B
A
DUST PORT
CLEANING AND EMPTYING THE
DUST CANISTER
To empty canister, hold canister and maintain a firm grip (Fig. 7). Firmly push upward on tab on corner of lid, and remove from canister. Knock excess dust out of the microfilter, or remove dust with your fingers or a soft brush. You may notice that all the dust may not come out of the canister. This will not affect sanding performance but will reduce dust collection efficiency.
NOTE: Do not wash the micro filter with soap and water. Dust may become more firmly lodged in the pores, which will reduce dust collection, and damage the micro filter.
FIG. 5
RELEASE
TABS
MICROFILTER
DUST
CANISTER
FIG. 6
FIG. 7
