BM 2610022228
Assembly & Preparation
CANISTER LATCH
CANISTER
VACUUM
HOSE
HOSE PORT
When unpacking, make sure that all of the standard equipment is present and that there is no transportation damage.
Before preforming any work on the machine itself, disconnect the power plug.
ATTACHING THE REAR WHEELS
1.Place one axle
2.Hammer pin into cap until the top of the pin is flush with the top of the cap.
3.Slide one wheel onto the axle, slide axle through the canister, then slide second wheel onto axle as shown in figure 3.
PIN | FIG. 3 |
AxLE CAP
WHEEL
CANISTER AxLE
4.Turn canister on its side.
5.Place second axle
6.Hammer pin into cap until the top of the pin is flush with the top of the cap.
ASSEMBLING THE MAIN HANDLE
The vacuum cleaner can be moved easily with the main handle. Always move the unit using both hands. Insert the handle into the two openings and fasten with the two handle clamps.
ATTACHING THE VACUUM HOSE
Connect the
HANDLE OPENING
FIG. 2
DUST BAG
The
The canister’s hose port also accept many other vacuum hoses, including most
DUST COLLECTION OPTIONS
There are four dust collection options: plastic bag, paper bag, slurry bag or no bag.
•The filter cartridges must be installed whether or not any of the bags are used.
Dry Vacuuming Notes:
•When
•Using a paper or slurry dust bag extends the amount of time the unit operates at high performance and extends the amount of time it takes for the filter cartridge to become clogged.
•A plastic bag can handle a heavier load without tearing than the paper or slurry bags.
•Using any of the three types of Bosch dust bags also makes waste disposal much easier, eliminating the cloud of dust that is created when canister contents are simply poured out, helping to protect you and the environment from exposure to the unwanted particles and debris.
Wet Vacuuming Notes:
•The VAC022