Tools for Assembly & Alignment
1
2
3
10mm/17mm Combination Open End Wrench
(supplied)
Combination Square (not included) 3mm Hex “L” Wrench
(supplied)
Multi-Purpose Tool with Bit (4mm/Philips #2)
(supplied, stored on the right rear base)
Combination Square Must be True
1. Use the straight edge of a 3/4" thick board (this
edge must be perfectly straight).
2. Draw a line on the board along this edge.
3. There should be no gap or overlap when the
square is flipped over in dotted position.
10.
Before moving the saw: Lock the
miter lock knob in 60° position. Lock
bevel lock handle. Lock head assembly in the down
position.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connections
could cause a fire.
Your new Model Miter Saw is shipped complete in
one box, But you may need to make some adjust-
ments and alignments before cutting final work-
pieces.
Separate all parts from packing materials and check
each one with the “Check List of Loose Parts” to
make sure all items are accounted for before dis-
carding any packing material.
Check List of Loose Parts:
■■Clamp (Item #37 on page 8)
■■Flip-Up Crown Stops (2) (Item #38 on page 8)
■■Dust Elbow/Dust Bag (Item #36 on page 8)
■■Multi Purpose Tool(See below)
■■Miter Lock Knob (Item #11 on page 8)
■■3mm Hex “L” Wrench (See below)
■■10mm/17mm Combination Open-End Wrench
(See below)
■■Arbor Laser / 3x Battery / Arbor Laser Manual
If any parts are missing, do not plug
in power cord or turn the switch on
until the missing parts are obtained and are installed
correctly.
WARNING
!
WARNING
!
Unpacking & Checking Contents