32.
Special Cuts
Cutting bowed material and round material are only
two examples of special cuts.

Cutting Bowed Material

If workpiece is bowed or warped,
clamp it with the outside bowed face
toward the fence. Always make certain that there is
no gap between the workpiece, fence and table
along the line of cut. Bent or warped workpieces can
twist or rock and may cause binding on the spinning
saw blade while cutting (Figure 1).

Cutting Round or Irregularly

Shaped Material

For round material such as dowel
rods or tubing, always use a clamp
or a fixture designed to clamp the workpiece firmly
against the fence and table.Rods have a tendency to
roll while being cut, causing the blade to “bite” and
pull the work with your hand into the blade (Figure 2).
Saw Operations (continued)
WARNING
!
WARNING
!
Bowed
Material
Fence
Workpiece
Clamp
No Gap at
this Point
Round
Material
Workpiece
Clamp
Fence
Figure 1. Bowed Material
Figure 2. Round Material