28.
Flip-Up Crown Stops /Length Stop
This tool comes equipped with a left and a right flip-
up crown molding stop. The stops can be stored
behind the fence for normal cutting operations, used
as a length stop, and can be easily flipped into posi-
tion to be used as a crown molding stop.
Instructions for installing the crown molding stops:
1.Locate the included 2 (two) flip up crown
molding/length stops (one left, and one right), 2
(two) knobs, and 2 (two) flat washers.
2.Hold one flip up crown molding/length stop to the
side of the sliding base and mount by screwing one
knob with washer through the slot of the stop and
into the rear mounting hole as shown in figure 1.
NOTE: there are 2 (two) holes on the rib of the slid-
ing base. Use rear hole for cutting most sizes of
crown moldings. Use front hole ONLY for large
crown moldings over 5-1/4” in size.

For Use As Crown Stop:

With the flip up crown molding stops now assembled
to the tool, simply loosen the knob enough for the
stops to move, position properly for use, and tighten.

For Storage On The Tool:

To move the stops out of the way for normal cutting
operations, simply loosen the knob, slide the flip up
crown molding/length stop all the way forward
towards the front of the tool, flip it over the fence,
slide the flip up crown molding/length stop into its
resting position, and re-tighten the knob. (Figure 2).
NOTE: for normal cutting operations without the
crown stop, or length stop being used, keep the stock
stop tab behind the stationary fence.

For Use As A Length Stop:

If the flip up crown molding/length stop is in the rear
(storage) position, you can set the stop by simply
unscrewing the knob and sliding the stop towards the
front of the tool until it stops and retighten the knob
(Figure 3).
Use only one length stop. Using
length stops on both sides of blade,
could trap workpiece and could cause workpiece to
be thrown.
The length stop can be used when making repetitive
cuts of the same length.
To set the cut length: unlock the base extension
clamping lever, reposition the base extension and
length stop, and relock the base extension clamping
lever.
The maximum length that can be cut using the length
stop is approximately 20”.
Saw Operations (continued)
Knob
Sliding
Base
Washer
Crown Stop
Length
Stop
Workpiece
WARNING
!
Figure 3: Length Stop
Figure 2: Storage Position
Figure 1: Crown Stop
Rear
Hole
Front
Hole