Safety Instructions for T4B Miter Saw Stand
Read and understand all
!WARNING instructions. Failure to follow all instructions listed below and in your miter saw manual may result in serious personal injury.
Fully assemble and tighten all the fasteners required for this stand. Also remember to occasionally check the stand and make sure it is still tight. A loose stand is unstable and may shift in use and cause serious injury.
Turn tool switch off and disconnect power before mounting to the stand. Unintended startup during assembly can cause injury.
Before operating, make sure the entire unit is placed on a solid, flat, level surface. Serious injury could occur if tool with stand is unstable and tips.
Never stand on tool or its stand or use as ladder or scaffolding. Serious injury could occur if the tool is tipped or the cutting tool is accidentally contacted. Do not store materials on or near the tool such that it is necessary to stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any others may create a hazard.
The Miter Saw should be firmly mounted to the stand per the instruction manual.
After mounting the Miter Saw to the stand, align, position and balance the Miter Saw per the instruction manual.
Before use, verify that all stand parts are free from damage and/or deformity.
Before use, verify that all parts or components of the stand are properly installed.
When mounting the Miter Saw to the stand, make sure that the tool mount handles are in the “UNLOCK” position, so the tool mount will engage with the main rail. Be sure to hold the saw until it is secured to prevent it from falling off the main rail. Handles should then be locked. (See page 10 for detailed instructions.)
When removing the Miter Saw from the stand, pull the tool mount handles until they rotate to the “UNLOCK” position. Hold the Miter Saw firmly to prevent the saw from falling off the main rail. Carefully remove the Miter Saw. (See page 10 for detailed instructions.)
Do not modify the stand in any manner or use the stand for any purpose other than is stated in these instructions.
Because cut material may cause the stand to become unbalanced, always be sure the material is supported properly. Also, if the piece being cut is placed far beyond the work support, the opposite side may suddenly be lifted up due to weight imbalance. To prevent this from occurring, hold the opposite side firmly before cutting.
This T4B
with the following miter saws:
Other units may be compatible, but have not been verified for use with the T4B system.
Bosch | DeWalt |
|
|
4212, 4212L, 4410, 4410L, | DW712, DW705S, DW703, | ||
4412, 4405, 5412L, 3912, | DW708, | DW706, | DW718, |
3915, 3918, 3924 | DW715, DW716, DW709 | ||
Delta | Makita | Ridgid | |
LS1214, LS1221, LS1013, | |||
MS1065LZ, MS1250LZ | |||
MS450 | LS1212, MS1214F |
|
Milwaukee | Ryobi | |
TS1353DXL, TS1341, TS1552 | ||
| ||
|
