Bosch Power Tools T4B manual Work Height Support Adjustment, Repetitive Stop Adjustment

Work Height Support Adjustment

1.Loosen the locking knob located at the end of the expansion rail, as shown in figure 16, and raise the work height support so it is level with the table top of the attached miter saw.

2.Retighten knob and repeat on opposite side.

Repetitive Stop Adjustment

To raise the repetitive stop: Lift up and in place as shown in figure 17.

To stow: Push the repetitive stop in toward the rail assembly and down.

Repeat on opposite side.

Cam Lever Adjustment

In the event the cam lever for the support leg loosens over time, tighten as shown in figure 18.

1.Place the cam lever in the “Locked” position.

2.Insert a flat head screw driver between the bottom of M8 Nylock nut and the rail.

3.Rotate the cam lever clockwise to tighten and counter-clockwise to loosen in order to achieve the appropriate feel and stability of the support leg.

FIG. 16

FIG. 17

FIG. 18

-11-