Step 5
Attach Rail Assembly
1.Locate the rail assembly and assemble as shown in figure 5.
2.Fold stand upright: Rotate release lever down to clear locking pins. With both hands on the handle, pull up and push forward on the stand until it locks into the upright position (see page 9).
3.Cut the strap restraining the support leg in place. Make sure the support leg is sitting on top of the base tube until the rail assembly is fully secured.
4.Place one (1) 6mm flat washer (R) onto one (1) 6mm x 45mm bolt (M).
5.Raise the rail assembly and align it with the holes in the long rail support. Prior to fastening the rail assembly, make sure the fastener access window on the long rail support and support link face down when the stand is in its horizontal position.
6.Insert one (1) 6mm x 45mm bolt (M) with 6mm flat washer (R) through the holes of the long rail support and the rail. Loosely tighten with one (1) 6mm lock nut (U).
7.Repeat step 6 of this procedure for the remaining three (3) hole locations in the long rail support and the four (4) hole locations in the support link assembly.
8.Securely tighten all eight (8) bolts.
Step 6
Secure Support Leg
1.Locate the support leg and secure as shown in figure 6.
2.Place one (1) 10mm flat washer (P) onto one (1) 10mm x 55mm Hex Head bolt (J).
3.Align the support leg with its hinge built into the base tube.
4.Insert one (1) 10mm x 55mm Hex Head bolt (J) with 10mm flat washer (P) through the support leg hinge and support leg. Place one (1) 10mm flat washer (P) and tighten with one (1) 10mm lock nut (S).
Note: Do not
FIG. 5
SUPPORT
LEG
FIG. 6
