Bosch Power Tools T4B manual Attach kick Bar, Attach Support Link Assembly

Step 3

Attach kick Bar

1.Locate the kick bar and position it between the left and right wheel/leg assemblies as shown in figure 3.

2.Place one (1) 10mm x 29mm OD flat washer (O) onto one (1) 10mm x 50mm Nylock hex head bolt (K). Insert bolt through the wheel/leg assembly and thread it into the the kick bar and securely tighten.

Repeat this procedure on other side.

Step 4

Attach Support Link Assembly

1.Unfold stand from vertical position:

With one hand on the handle, foot on the kick bar, pull back slightly and rotate the release lever to disengage the locking pins. With both hands on the handle, pull back, push down, and lower the stand until it locks in position.

2.Locate the support link assembly and assemble as shown in figure 4. Note the “R” and “L” stickers for proper orientation.

3.Place one (1) 10mm flat washer (P) onto one (1) 10mm x 100mm bolt (I).

4.Insert bolt through wheel/leg assembly and place one (1) 10mm flat washer (P) on bolt between wheel/leg and support link assemblies.

5.Insert bolt through support link assembly, place one (1) 10mm flat washer (P), and loosely tighten with one (1) 10mm lock nut

(S).

Note: Do not over-tighten lock nut. These parts need to freely rotate for stand to operate properly.

Repeat this procedure for the opposite side.

FIG. 3

FIG. 4

-6-