Bose AM259777 manual Connecting the Acoustimass module to the media center, Audio input cable

System Installation Instructions

Connecting the Acoustimass® module to the media center

Connect the Acoustimass module to the media center with the audio input cable (Figure 10).

Note: Be sure that each connector is fully inserted into each jack.

1.Plug the small black multi-pin connector (flat side facing up) into the SPEAKER ZONES jack labeled “1” on the back of the media center.

2.Insert the telephone-style RJ-45 connector on the other end of the audio input cable into the AUDIO INPUT jack on the Acoustimass module. When properly connected, it should lock in place.

Note: Refer to “Setting up a second listening zone” on page 25 for information on connecting a second zone.

Figure 10

Acoustimass module con- nection to media center

33V

DC POWER

RECORD

TAPE

AUX

VCR

TV

TV

1.1A

SENSOR

VIDEO INPUTS

AM

L

L

L

L

L

COMPOSITE

S-VIDEO

FM

75

IR

ANTENNA

EMITTER

1

R

R

R

R

R

1

OPTICAL

OPTICAL

SERIAL

DATA

2

INPUT

OUTPUT

DIGITAL

DIGITAL

DIGITAL

DIGITAL

DIGITAL

SPEAKER

COMPOSITE

S-VIDEO

ZONES

AUDIO OUTPUTS

AUDIO INPUTS

VIDEO OUTPUTS

Acoustimass module

connector panel

AUDIO	OUTPUTS TO
INPUT	CUBE SPEAKERS
	FRONT	SURROUND	POWER	100-120/200-240V AC
				50/60 Hz
				350W MAX.
L
C		L
R		R

Audio input cable	Note: Press tab to release cable connector.
	When fully inserted into the jack, the connector
	locks in place.

CAUTION: Do not place strain on the audio input cable, especially on the connection to the Acoustimass module. Placing excessive strain on the cable may cause damage to the cable connection at the Acoustimass module. When disconnecting the cable from the Acoustimass module, be sure to press the tab on the connector.

13

AM259777_02_V.pdf • April 23, 2002