Bose AM259777 Connecting the system to power, Headset connection for use in the final setup steps

System Installation Instructions

Making the temporary headset connection before connecting to power

Plug the special headset connector into the AUX jacks on the rear of the media center (Figure 17). This is for temporary use during steps for “Finishing the installation” on page 21.

Figure 17

Headset connection for use in the final setup steps

	33V	DC POWER				RECORD	TAPE	AUX	VCR	TV
TV	1.1A
SENSOR
			AM			L	L	L	L	L
				FM	75
IR			ANTENNA
EMITTER
		1	OPTICAL	OPTICAL		R	R	R	R	R
							R
SERIAL
DATA
		2	INPUT	OUTPUT		DIGITAL	DIGITAL	DIGITAL	DIGITAL	DIGITAL
		SPEAKER
		ZONES			AUDIO OUTPUTS			AUDIO INPUTS
								AUX

VIDEO INPUTS

COMPOSITE	S-VIDEO
COMPOSITE	S-VIDEO
VIDEO OUTPUTS

5

Temporarily remove the cable/satellite box cable if it is connected

Connecting the system to power

Figure 18

Connect the two AC power (mains) cords in the following order:

1.Plug the small end of the Acoustimass® module power cord into the AC power jack on the connector panel of the Acoustimass module (Figure 18). Plug the other end of the power cord into an AC (mains) outlet.

2.Turn the Acoustimass module POWER switch to on ( l ).

Power connection of the Acoustimass module

RR

CL

FRONT SURROUNDPOWER 100-120/200-240V AC 50/60 Hz 350W MAX. L

INPUT	AUDIO
CUBE SPEAKERS	OUTPUTS TO

Connector panel

Power switch

19

AM259777_02_V.pdf • April 23, 2002