Accessories, Technical information | Bose AM267565 specs

Reference

Accessories

•Drop Ceiling Kit for two speakers – PC031355

Protects the tile from bearing the weight of the speakers. Instructions included.

•Rough-in Kit for two speakers – PC031353

Reserves a place for the speakers after the studs are in place and before the wallboard is added, and indicates where the wallboard hole should be made. Instructions included.

For further information or to order accessories, contact your Bose® dealer. Or, to call Bose directly, refer to the address list included in the carton.

Technical information

Features

•Virtually Invisible® and Articulated Array® speaker design

•Proprietary enclosure technology

•Stereo Everywhere® speaker performance

•Paintable grille

•Syncom® computer tested

Compatibility

•Compatible with ampliﬁers or receivers rated 10-100W per channel/rated 4 to 8 ohms

•50W IEC continuous power handling; rated 6 ohms

Driver complement

• Two (2) 21/2" (6.4 cm) full-range drivers per speaker

Enclosure

•Ported and molded high-impact polystyrene

•White frame and grille

Dimensions

•Each speaker:

133/4"H x 77/8"W x 37/8"D (34.9 cm H x 19.9 cm W x 9.8 cm D)

•Wall or ceiling surface area required for each:

Rectangular-faced speaker – 83/4"W x 6"H (20.5 cm x 14 cm) Round-faced speaker – 101/4" diameter (26 cm)

Weight

• 4.5 lb (2.0 kg) each

AM267565_01_V.pdf May 13, 2003

33

Image 33

Bose AM267565 manual Accessories, Technical information

Contents

Bose Virtually Invisible 191 Speakers Important words of caution Safety Information Contents Introduction Before you beginWhat makes this speaker better also makes it different Preparation UnpackingOther equipment you’ll need Considering your wall type and the approach it requires Consider which shape you prefer for your speakersOptional items Installing in a pre-wired room Accessories that can helpHow to determine pre-wiring What to do when the room is not pre-wired Deciding on speaker placement Installing in an exterior wallSpecial considerations in cold climate regions Select the general wall area for one speaker For Cutting Wire recommendations Using speaker cordPlanning to run speaker cord Prepare the cord Preparation Before the wallboard goes up Where the walls are ﬁnished Getting started Drill a pilot hole for testing the wall space Steps to InstallingUsing the template for this ﬁrst step Before you make any holes Pilot hole Drilling the pilot hole Use the bent wire to test for enough depth, front-to-back Testing the space behind the hole Checking the space for the width of the speaker Passing the pilot hole test Repairing a pilot hole Prepare the wall for inserting the speaker Using the template a second time Cutting the speaker hole If you encounter insulation behind the wall Insert and wire the speaker Insert the speaker into the opening Speaker held in place by wall stops Test the speaker now Make the speaker connections To test the speaker Secure the speaker to the wall When the grille is ﬁnally in place Choosing to paint the speakersIf the speaker looks crooked Using a dry brush technique Using a spray techniquePainting the grille Steps for spray painting Painting the frame Customer service TroubleshootingWarranty period Reference Technical information Accessories