Svenska | Nederlands | FrançaisItliano | DeutschEspañol |
English
SETUP
To get digital audio from the component
For a component that is already connected to the media center, you can make a digital audio connection too.
For this higher quality audio, you need a digital audio cable that works with your component. Such cables are available at most electronics stores.
1.Identify the digital connector on your component as either an Optical or Coaxial connector.
Coaxial
Optical
2.Be sure to use the right cable for this connector.
Optical OR Coaxial
3.Connect one end of your digital cable to the digital AUDIO OUT connector on your component.
Be sure to keep the red and white audio cable connected. This allows you to hear the audio if the program audio is not digital or the digital signal is interrupted.
4.Locate the appropriate digital AUDIO IN connector, labeled D, on the system media center.
You can make:
•up to 3 coaxial connections
•up to 2 coaxial and one optical connection
Note: If your component has an Optical and a Coaxial connector, use either one but not both.
Note: The media center Optical connector is factory set to work with a cable or satellite box. If your Optical component is neither of those, you need to select your component in an
20
