Bose L1 Model II manual Connections and controls, Signal/Clip LED

Svenska Nederlands Italiano FrançaisSvenska NederlandsEspañol FrançaisDeutschItliano DeutEspañolchDank EnglishDansk

INTRODUCTION

Connections and controls

The top panel of the power stand provides system connectors and controls (Figure 2).

Figure 2

Power stand top panel

Power/Fault LED

Indicates power status.

Blue = system on

Red = system fault

AC Mains AC power input

connector.

Bass - Line Out Post-DSP bass signal output. Accepts a ¼" TRS phone cable. Used to drive a PackLite® power amplifier.

Analog Input

Aline-level analog input. Accepts a ¼" TRS phone cable. Used for an instrument or other audio source.

Signal/Clip LED

Indicates status of the analog input signal. Green = normal input

Yellow = input approaching clipping Red = input clipping

Power switch Switches the system on and off.

Bass Module Out

Bass output signal for driving one or two B1 bass modules. Accepts a 4-wire bass module cable.

Trim

Adjusts the level of the analog input signal.

ToneMatchTM port

Digital audio and power con- nection for the optional T1 ToneMatch audio engine. Accepts the included ToneMatch cable.

6