EnglishDansk

DeutEspañolchDank

FrançaisDeutschItliano

NederlandsEspañol

FrançaisSvenska

Italiano

Nederlands

Svenska

OPERATING INFORMATION

Setting the analog input level

When connecting an audio source to the Analog Input, follow these steps to adjust the input Trim control.

1.Set the Trim control on the power stand to the 0 (zero) position.

2. Connect the audio source to the Analog Input.

3.Adjust the volume of the audio source to the desired level.

4. While playing the source, increase the Trim level until the Signal/Clip indicator glows green or yellow.

5.If the Signal/Clip indicator glows red, decrease the Trim level so that it glows only green or yellow.

Using a T1 ToneMatchTM audio engine and an analog input source

The L1TM model II system can operate with both a T1 ToneMatchTM audio engine and an ana- log audio source connected to the power stand. However, keep in mind that the volume level of the audio engine and the analog audio source is adjusted independently.

The power stand Trim control only affects the volume level of the analog audio source con- nected to the Analog Input. Therefore, the Signal/Clip indicator indicates the status only of the analog input signal.

The T1 ToneMatch audio engine has a Trim control and signal/clip indicator for each input, a Volume control for each output channel, and a Master volume control that adjusts the level of the ToneMatch output sent to the power stand. These controls have no effect on the signal fed to the Analog Input.

User scenarios

There are many ways to set up and use this system with and without the T1 ToneMatch audio engine. The following pages show examples of some typical user scenarios. When using the T1 ToneMatch audio engine, refer to its owner’s guide for more information on setup and operation.

Single musician

A solo musician might play a single instrument through the L1 model II system (Figure 11). A solo musician also might play an instrument and use a microphone for vocals (Figure 12 on page 16).

Figure 11

Single L1 model II system with keyboard

15

Page 23
Image 23
Bose L1 Model II manual Operating Information, Setting the analog input level, User scenarios, Single musician