EnglishDansk | DeutEspañolchDank | FrançaisDeutschItliano | NederlandsEspañol | FrançaisSvenska | Italiano | Nederlands | Svenska |
SYSTEM SETUP
Setting up the L1TM model II power stand
1.Holding the power stand vertically on the foor (Figure 4A), grasp one leg and swing it out as far as it will go. Notice that the other legs swing out automatically. The legs must be fully open before you can plug the L1TM bottom section into the power stand.
2.Lay the power stand flat on the floor in the desired position (Figure 4B).
Figure 4
Putting the power stand on the floor
A 
B
Socket for
L1 bottom
WARNING: DO NOT move the completely assembled system as a unit. This could result in personal injury and/or damage to the product. Position the power stand on the floor in the chosen location before assembling the system.
Assembling the L1 model II Cylindrical Radiator® loudspeaker
Figure 5
Setting up the L1 model II Cylindrical Radiator® loud- speaker top and bottom
This procedure tells you how to set up the loudspeaker sections in the power stand. If you plan to mount the T1 ToneMatchTM audio engine on the L1 model II system, see “Adding a T1 ToneMatchTM audio engine (optional)” on page 12 before installing the top section of the loud- speaker.
1.Hold the L1 bottom so that the grille faces front and plug it into the power stand (Figure 5A). Be sure to fully insert it into the socket to assure stability and a good connection.
2.Align the bayonet on the L1 top with the channel on the back of the L1 bottom, and lower the L1 top onto the L1 bottom until it is flush (Figure 5B).
A | B | Bayonet |
|
| |
| L1 top |
|
Channel
L1 bottom
Front of 
system
9
