EFFECT
22

DIVIDER

Within the eect chain, the point where the signal is split into channels

“A” and “B” is called the “divider,” and the point where the two signals are

recombined is called the “mixer.”

You can use the divider to switch between channels “A” and “B,” to assign

strongly picked notes and softly picked notes to dierent channels, or

to assign dierent frequency bands of your guitar sound to dierent

channels.

The mixer lets you adjust the volume balance of channels “A” and “B,”

place them in the stereo eld, or slightly delay the sound of channel “B” to

produce a spacious sound.

DIVIDER MIXER
Parameter Value Explanation
MODE SINGLE Use only one channel, either “A” or “B.”
DUAL Use the two channels “A” and “B.”

SINGLE

Parameter Value Explanation
CH SELECT Ch. A, Ch. B Selects the channel to use.

DUAL Ch. A, DUAL Ch. B

Parameter Value Explanation
Ch. A/Ch. B
DYNAMIC
OFF DYNAMIC will not be used.
POLAR+ Only notes picked more strongly than the
DYNAMIC SENS setting will be output.
POLAR- Only notes picked more softly than the
DYNAMIC SENS setting will be output.
Ch. A/Ch. B
DYNAMIC
SENS
0–100 Species the picking sensitivity.
Ch. A/Ch. B
FILTER
OFF The lter will not be used.
LPF Only the region below the cuto frequency
will be output.
HPF Only the region above the cuto frequency
will be output.
Ch. A/Ch. B
CUTOFF FREQ 100 Hz–2 kHz Cuto frequency

MIXER

Parameter Value Explanation
MODE
STEREO Channels “A” and “B” will be mixed and output
in stereo.
PAN L/R Channels “A” and “B” will be assigned
respectively to the L and R OUTPUT jacks.
CH A/B
BALANC 100:0–0:100
Adjusts the volume balance of channels “A”
and “B.”
* This is shown only if DIVIDER MODE is set
to “DUAL.”
SPREAD 0–100
Slightly delays the sound of channel “B” to
make the sound more spacious.
* This is shown only if DIVIDER MODE is set
to “DUAL.”