SYSTEM
28

PREFERENCE

Here you can specify whether settings for the type of connected amp and

preamp, control pedal, expression pedal, etc. will be independent for each

patch, or whether the same settings will be shared by all patches.

Parameter Value Explanation
OUTPUT
SELECT PATCH, SYSTEM If this is set to PATCH, dierent settings can
be made independently for each patch. If this
is set to SYSTEM, the same settings will be
shared by all patches.
* Here, even if a CTL/EXP pedal that has been
set to SYSTEM is set to ASSIGN SOURCE (p.
32), that setting will be ignored. In the case
of the ACCEL/CTL pedal, in addition to the
above, settings for Manual mode (p. 37) will
also be ignored.
PREAMP PATCH, SYSTEM 1–3
ACCEL/CTL PATCH, SYSTEM
EXP PATCH, SYSTEM
EXP SW PATCH, SYSTEM
SUB CTL 1 PATCH, SYSTEM
SUB CTL 2 PATCH, SYSTEM
SUB EXP PATCH, SYSTEM

LCD

Here you can adjust the brightness of the characters in the display.

Parameter Value Explanation
CONTRST
LEFT 1–16 Higher values increase the brightness.
CONTRST
RIGHT

USB

Here you can make USB-related settings for when the GT-100 is connected

to a computer via USB.

USB audio ow

MIX
Level
OUTPUT
Level
GT-100
USB IN
USB OUT
INPUT
OUTPUT
Eect Chain
USB IN-OUT MODE: NORMAL
MIX
Level
OUTPUT
Level
Eect Chain
GT-100
USB IN
USB OUT
INPUT
OUTPUT
USB IN-OUT MODE: DRY OUT
INPUT
Level
OUTPUT
Level
Eect Chain
GT-100
USB IN
USB OUT
INPUT
OUTPUT
USB IN-OUT MODE: REAMP
Parameter Value Explanation
USB IN-OUT
MODE
Here you can specify the audio ow for USB input/output.
NORMAL
The guitar input will be sent through the
GT-100’s eects and output to the computer. The
input from the computer will be mixed with the
GT-100’s output, and then output.
DRY OUT
The sound of the guitar processed by the eects
will be monitored, while the guitar input will
be output to the computer without passing
through the GT-100’s eects. The input from the
computer will be mixed with the GT-100’s output
(eect-processed guitar sound) and then output.
REAMP
The sound being input from the computer will
pass through the GT-100’s eects, and then be
output from the GT-100’s OUTPUT and USB OUT.
With this setting, the guitar sound recorded on
the computer can be played back through the
GT-100’s eects and output from the GT-100’s
guitar OUTPUT and USB OUT.
* If REAMP is selected, the GT-100’s INPUT
cannot be used.