BOXLIGHT CP-33t manual Appendix, Problem, Try these Solution, Remote Control Unit

APPENDIX

Problem:	Try these Solution
Remote Control Unit	● Check the batteries.
does not work.	● Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
	● Make sure nothing is between the Remote Receiver and the Remote Control Unit.
	● Make sure you are not too far from the projector when using the Remote Control Unit.
	Maximum operating range is 16.4’ (5m).
Wireless Mouse	● Check the cable connection between the projector and the computer.
function does not	● Check the mouse setting on your computer.
	● Turn the projector on before you turn on the computer.
work.
The image data in	● Check the memory card is inserted properly into PC CARD SLOT.
memory card isn’t	● Check SmartMedia or PC Card Adapter is set properly.
	● Check MCI mode is selected.
displayed.
	● Check the image data is recorded in the memory card properly.
	● Start the projector again.
The image data can’t	● Check the projector is turned on.
be written in, read	● Check “Card access” in VIEW menu is selected.
	● Check Control Cable for Serial Port (optional) is connected properly.
from the memory
	● Check the memory card is inserted properly into PC CARD SLOT.
card.
	● Check Media Card Imager (supplied) is installed in your computer properly.
	● Check the setting in Media Card Imager (like Serial Port Setting) is set properly.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

Boxlight Service is easily obtained. If after following instructions above, you find that service is necessary, contact Boxlight for assistance at 1-800-762-5757 or 360-779-7901.

Give the model number and explain the difficulty. We will advise you how to obtain service.

Please have the following information available.

●Serial No. of projector.

●Resolution of the computer.

●Refresh rate of computer.

45