BOXLIGHT CP-33t manual Preparation Connecting The Ac Power Cord, Ventilation

PREPARATION

CONNECTING THE AC POWER CORD

This projector uses nominal input voltages of 100-120V AC or 200-240V AC. The projector automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if your are not sure of the type of power supply being in use. Connect the projector with the peripheral equipment before turning the projector on. (Refer to pages 10 ~ 13 for connection.)

CAUTION

For safety, unplug the AC Power Cord when the appliance is not in use.

When this projector is connected to the outlet with the AC Power Cord, the appliance is in Stand-by Mode and consumes some electric power.

Connect the AC power supply cord (supplied) to the projector.

The socket-outlet must be near this equipment and must be easily accessible.

Projector side (Female) AC outlet side (Male)

VENTILATION

This projector is equipped with cooling fans for protection from overheating. ensure ventilation and avoid a possible risk of fire and malfunction.

●Do not cover the vent slot.

●Keep the rear grill at least 1m (3 feet) away from any object.

●Keep sides clear of any obstructions. Obstructions may block cooling air.

Pay attention to the following to

EXHAUST VENT

(REAR SIDE)

AIR INTAKE VENTS (BOTH SIDES)

8