Commercial Models (see Figure 11):
1.Commercial models are supplied in the water heater carton with a Remote Main Control, which will allow the outlet water temperature to be adjusted from
2.All hot water faucets must be off to get the full range of temperature adjustment. The control will only allow an adjustment range of
3.Press the “H” or “C” buttons until the desired temperature is shown on the display.
4.The water heater will automatically start heating water whenever a hot water faucet is opened. The remote temperature control(s) will indicate hot water use with the green “IN USE” indicator.
5.All controls can also display diagnostic error codes, water flow rate through the unit (in gallons per minute) and the outlet water temperature.
6.Pressing the “Priority Button” followed by the “H” button will display a sequence of up to 9 error codes, if any, stored in memory that has been experienced. Any error codes will be displayed on the digital monitor in sequence starting with the most recent code.
7.To display the water flow through the water heater with hot water in use, depress the “H” button for 2 seconds and then simultaneously press the “P” button. (GPM = Display Readout X 0.1).
8.To display the outlet water temperature while in use, depress the “C” button for 2 seconds and then simultaneously press the “P” button.
°F
Priority
Set Temperature | In Use |
|
Main Controller
endless hot water system
CAUTION: Hotter water increases the risk of scald injury. Before changing temperature setting, see instruction manual.
Control for Commercial Models (Fig 11)
32
