Pre-Lift Operation Notes and Details
Lift Features (continued)
driven roll stop is powered by the roll stop cylinder to auto- matically fold (rotate) to the vertical position when the UP switch is activated.
WARNING
Discontinue lift use immediately if any lift component does not operate properly. Failure to do so may result in serious bodily injury and/or property damage.
Roll Stop Latch: A spring- loaded latch engages the outboard roll stop when the roll stop rotates upward from ramp position to the vertical position (UP switch is acti- vated to raise the platform above ground level).
Note: The platform must raise approximately two inches before the latch engages fully (see photo C on 17). L955U: The roll stop latch and roll stop cylinder are on the opposite (left) side of platform.
The latch disengages the roll stop when the platform lowers fully (reaches ground level) and the latch foot contacts the ground (latch raises above the
roll stop).
Outboard Roll Stop and Roll Stop Latch Operation: The lift
The lift operator or attendant must be certain the entire platform reaches and rests safely on the ground.
Page 18
