A&D HW-100KGL, HG-60KGV, HW-60KGL, HW-200KGL Printing condition when using option OP-06 for type

Item	Display		Meaning and purpose
Accumulation			When the display becomes a stable value, the scale
			accumulates the data automatically. Next accumulation can
			occur after the display becomes near-zero.
	f8	4	Use: Recording number and mass of articles removed from
			the pan. (Put articles on the pan. Press					TARE	switch at each
			removal.)
			At each finish of full/dribble batch function, the scale
			accumulates the data automatically.
	f8	5	Use: Packing articles like a powder, it is used for recording
			the bag number and total mass.
			The printing condition when using option OP-06 for type V.
	f9	0 #	No print.
	f9	1	Pressing the				switch, the data is output.
					PRINT
			Auto-print +
			When the display becomes a positive stable value above
	f9	2	near-zero, the scale outputs the data automatically. Next
			output can be performed after the display becomes near-
			zero or negative value.
Print Mode			Auto-print +/-
			When the display becomes a stable value outside near-zero,
	f9	3	the scale outputs the data automatically. Next output can be
			performed after the display becomes near-zero.
	f9	4	At each finish of full/dribble batch function, the data is output.
	f9	5	When the accumulation function is used, the data is output.
			The details of the full/dribble batch function (B$￿')
	f10 0 #		Reaching final value and pressing the F switch, the current
			process is finished.
	f10 1		Reaching final value and displaying the stability mark, the
			current process is finished automatically.
	f10 2		Pressing the			switch, the scale automatically tares and
					SET
			starts the full/dribble batch process. Reaching final value and
			pressing the F switch, the current process is finished.
Full/Dribble	f10 3		Pressing the			switch, the scale automatically tares and
				SET
Batch			starts the full/dribble batch process. Reaching final value and
sub-function			displaying the stability mark, the current process is finished.

Address for RS-422 / RS-485 for option OP-04

Address

f11	00	# Use This address can be set from 01 to 99. Allows a
to		computer to control a scale with the assigned address.
f11	99	(RS-232C should be set to “00”.)

HW-G OZIM v1a

HW-G Instruction Manual Page 46