HW-G Instruction Manual Page 60
HW-G OZIM v1a
ZeroThe current mass value is set to the zero point, this is same as the
ZERO
switch.
Template Z
Command
Reply The mass value becomes zero and zero point mark is displayed.
TareThe current mass value becomes zero after placing a tare (receptacle, case, etc)
and the net is displayed. This is same as the
TARE
switch
.
Template T
Command
Reply The current mass value becomes zero and net mark is displayed.
Cancel of tareThe display value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template CT
Command
Reply Gross is displayed and the net mark is turned off.
Preset tareThe tare value is set and the net is displayed. The net mark is displayed.
Template PT,[parameter]
Command
Reply Net is displayed.
Upper limit valueAn upper limit value is stored.
Template HI,[parameter]
Command
Reply The upper limit value is stored.
Lower limit valueA lower limit value is stored.
Template LO, [parameter]
Command
Reply The lower limit value is stored.
Caution The lower limit value must be less than the upper limit value.