Set switch.
Can be used to turn the comparator on/off. (Refer to f6 ) Counting mode, it is used to enter the mode to store the unit mass. Percentage mode, it is used to enter the mode to store the 100% mass.
In the full/dribble batch function, it is used as a start switch.
In the preset tare, and selecting calibration mass, it is used to select a figure.
Mode switch.
Used to change the current unit.
While setting modes, this switch is used for “storing a parameter and proceeding the next step”.
F switch
Full/dribble batch function it is used to finish the process. (Refer to f10 )
Hold switch. (Refer to f12 )
Setting a preset tare, selects polarity
Print switch.
Used to print or output data. (Refer to f5, f9 )
Used to enter the function table
Used to enter the mode to set a preset tare
Used to perform paper feed for the optional printer for type V.
