Bretford LAP30EBA manual Cutout window Clip-rear Round cutout

cutout window

clip-rear

round cutout

Figure 1

Step 4

Carefully install replacement E-Unit(s) into position by placing bottom in first and tilting in sideways to the top. When repositioned correctly, the E-Unit(s) power switch should be visible from rear panel cutout window. Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the bracket assembly) and tighten screws securely.

Feed the E-Unit power cord(s) [plug end] all the way through the bottom rear grommeted round coutout(s) [next to the bracket assembly] shown in Figure 1.

Wind power cord(s) around the cord wrap bracket(s) located on the exterior of the rear panel for storage.