offset
front-left 
clip
front-right
bottom shelf
Step 3
Carefully install replacement E-Unit(s) into position by placing bottom in first against the offset and tilting it in sideways to the top.
When repositioned correctly, the E-Unit(s) power switch should face the front.
Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the bracket assembly) and tighten screws securely.
From underneath the bottom shelf, feed the E-Unit power cord(s) [plug end] all the way through the bottom rear round grommeted cutout(s) [next to bracket assembly].
Press each E-Unit power cord into the two wire clip(s) located [in line, behind E-Unit] on the bottom of cart. Wind power cord(s) around the cord wrap bracket on the exterior rear panel for storage.
Installation is now complete and ready for use.
