cutout
window 
clip-rear
round cutout
Step 5 | Figure 1 |
|
Reinstall the E-Units (set aside from being removed from the front) as follows: | |
1.Rotate the E-Unit 180 degrees (from original position).
2.Cross over to opposite corner of cart.
3.Tilt in and set bottom in back, in front of rear panel cutout window.
4.Grip the top and tilt to the upright position, underneath top panel bracket.
When repositioned correctly, the E-Unit power switch should be visible from rear panel cutout window.
Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the bracket assembly) and tighten screws securely.
Feed the E-Unit power cords (plug end) all the way through the bottom rear grommeted round coutouts (next to the bracket assembly) shown in Figure 1.
Wind power cords around the cord wrap brackets located on the exterior of the rear panel for storage.
