Operating your Infuser™ Espresso Machine
Operating your Infuser™ Espresso Machine
Filling the Water Tank
• | Ensure the water filter is securely fitted |
| inside the tank. |
• | Fill the water tank with cold tap water |
| to the maximum mark on the side of the |
| tank and slide the water tank back into |
DOSING & TAMPING THE GROUND COFFEE
• | Fill the portafilter with freshly ground |
| coffee. |
• | Once the portafilter has been filled, |
| tap to collapse coffee grinds. Using the |
PRE-PROGRAMMED
SHOT VOLUME – 1 CUP
Press the 1 CUP once. A preset volume of approximately 30mls will be extracted. The machine will automatically stop once the preset volume has been extracted.
NOTE
Pressing the 1 CUP or 2 CUP buttons during a programmed espresso will immediately stop the extraction.
position at the back of the machine. |
• Plug the power cord into power outlet |
and switch On at power point. |
• Press the POWER button to On. The |
POWER button surround will flash |
while the machine is heating. When the |
correct temperature has been reached, |
all the button surrounds on the control |
panel will illuminate. |
NOTE
Check the water level before use and replace the water daily. The water tank should be filled with fresh, cold tap water before each use.
Do not use mineral or distilled water or any other liquid.
integrated tamper, tamp down firmly |
using approx. |
You may need to adjust the grind amount a few times to achieve the correct grind amount.
NOTE
When using a finer espresso grind for the Single Wall Filter basket, you will need to increase the grind amount to ensure the filter is correctly dosed.
NOTE
The amount of espresso extracted in the cup will vary depending on your grind size and dose amount.
PRE-PROGRAMMED
SHOT VOLUME – 2 CUP
Press the 2 CUP button once. A preset volume of approx. 60mls will be extracted. The machine will automatically stop once the preset volume has been extracted.
PROGRAMMING SINGLE ESPRESSO
1.To begin programming, press the PROGRAM button once. The machine will beep once and the program button will begin to flash. This indicates the machine is in programming mode.
2.Press 1 CUP button to start espresso extraction. Press 1 CUP again once desired volume of espresso has been extracted. The machine will beep twice to indicate the new 1 CUP volume has been set.
PROGRAMMING DOUBLE ESPRESSO
1.To begin programming, press the PROGRAM button once. The machine will beep once and the program button will begin to flash. This indicates the machine is in programming mode.
2.Press 2 CUP button to start espresso extraction. Press 2 CUP again once desired volume of espresso has been extracted. The machine will beep twice to indicate the new 2 CUP volume has been set.
12 |
| 13 |
|
|
|
