Niles Audio ZR-6 manual Page Mode Volume, Maximum Volume Level, System Configuration

SYSTEM CONFIGURATION

CONFIGURING THE ZR-6 MULTIZONE RECEIVER

Press the + button or - button to toggle the cursor between the zones . A “Y” appears under every zone number. The cursor under the zone number blinks when a zone is highlighted.

Press the Band button to toggle the “Y” on or off in the highlighted zone. Only zones with a “Y” will respond to whole house turn on.

1	2	3	4	5	6	P	A	R	T	Y
Y	Y	Y				M	A	S	T	E	R

NOTE: IN THIS EXAMPLE ZONES 1, 2 AND 3 ARE CONFIGURED FOR PARTY MODE.

After “6” on the Master, it will toggle to “1” on the fi rst connected Slave. After “6” on the last connected Slave, it will toggle back to “1” on the Master.

Repeat these steps until all of the desired zones have been set for the desired Party mode operation.

To continue to the next system confi guration step, PAGE MODE VOLUME, press the Set button once.

To save the settings and exit the confi guration mode, simultaneously hold down the Band and Set buttons. After the ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE] appears on the display. The ZR-6 will return to the normal operating mode.

PAGE MODE VOLUME

The paging volume level for the selected zones is adjustable. Paging level must be set on each slave as well as the master. Since the paging volume level will be the same for all zones connected to that chassis, we suggest setting a comfortable level in the room that will be used most frequently, or in the smallest room. While in the confi guration mode (see above), press the Set button until [PAGE MODE VOLUME = XX] shows in

the display.

P A G E M O D E

V O L U M E = 6 0

Press the + button to increase the paging volume. Press the - key to decrease the paging volume. The factory default setting is 60. The volume range is from 0 to 99.

NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373

P A G E M O D E

V O L U M E = 3 4

To continue to the next system confi guration step, Zone 4 Pre-Out, press the Set button once.

To save the settings and exit the confi guration mode, simultaneously hold down the Band and Set buttons. After the ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE] appears on the display. The ZR-6 will return to the normal operating mode.

MAXIMUM VOLUME LEVEL

A Maximum Volume Level can be confi gured for each zone. The volume level in zone will never exceed this Maximum level. The default maximum volume level in a zone is 100%. When the volume in a zone is at the maximum level, the volume bar indicator on the keypad or touch panel shall indicate 100%.

While in the confi guration Menu, press SET until [SET MAX VOLUME] is displayed.

S E T M A X V O L U M E

- / N O + / Y E S

Press + to confi gure Maximum Volume levels for each zone. [ZONE 1 MAX VOLUME] will appear on the display. Press the – button to move to the next confi guration step without setting maximum volume levels.

Z O N E 1 M A X V O L U M E

V O L U M E = 9 0 M A S T E R

Press + to raise the volume and press – to lower the volume. Press SET to save the maximum volume setting and move to the next step. After Zone 6 on the Master, Zone 1 on Slave 1 (if connected) will be displayed. After Zone 6 on Slave 2 (if connected), the

confi guration menu will move to Zone 4 Pre out on the Master

Z O N E 2 M A X V O L U M E

V O L U M E = 1 0 0 M A S T E R

37