Niles Audio ZR-6 manual Ir Programming, Programming Source Device Ir Command Codes

IR PROGRAMMING

PROGRAMMING SOURCE DEVICE IR COMMAND CODES

3.Press the Next button to proceed to the next command code. Follow steps 1 and 2 above for each command code that is to be edited or erased.

4.Press the Program button to advance to the next source device to be edited.

ERASING INDIVIDUAL DEVICE SEQUENCES

1.While in programming mode, press the Program button until the desired source sequence page is shown on the display.

P R O G T U N E R 0 1

B U I L D S E Q U E N C E

2.To erase the sequence for the displayed device, press the Erase button.

3.The display will show [ERASE SEQUENCE -/NO +/ YES]

E R A S E S E Q U E N C E

-/ N O + / Y E S

4.Press the + button to erase the sequence. The sequence that was previously stored in this location is now erased.

5.Press the – button to exit erase mode and return to the previous step without erasing the sequence.

ERASING ALL IR COMMAND AND SEQUENCE PRO- GRAMMING FOR ONLY ONE SOURCE

1.While in the Programming mode, press Program until the desired source device name is displayed with [TEACH POWER ON] or if a library page [ENTER NILES]

P R O G S O U R C E 3

T E A C H P O W E R O N

3.The display will show [ERASE ALL IR+SEQ “SRC 3” -/NO +/YES]

E R A S E A L L I R + S E Q

L I B 1 - / N O + / Y E S

4.Press + to erase the commands and sequences for the selected device. The commands and sequences that were previously stored in this location are now erased.

5.Press – to exit erase mode and return to the previous step without erasing the commands and sequences.

6.Continue erasing or press-and-hold the Program button to exit IR Programming mode.

ERASING IR AND SEQUENCE PROGRAMMING FOR ALL SOURCES

1.While in the programming mode, press-and-hold the Program, Next and Erase buttons until the display shows [ERASE ALL IR+SEQ PRGM -/NO -/YES].

E R A S E A L L	I R + S E Q
P R G M - / N O	+ / Y E S

2.Press the + button to erase all IR commands and sequences. All commands and sequences that were previously stored in the ZR-6 are now erased.

3.Press – button to exit erase mode and return to the previous step without erasing any commands and sequences.

4.Press-and-hold the Program button to exit IR Programming mode.

2. Press-and-hold the Program and Erase buttons.

(CONTINUED ON NEXT PAGE)

NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373 49